Fixing a flickering light could be as easy as tightening a bulb that’s making a poor connection. If there is one bulb and it’s toast, the fixture won’t turn on. Sometimes we overlook the easiest solution. But if you’re still inclined to investigate, here’s what to look for. Electricians are specifically trained to fix dead outlets. According to the CDC, more than 400 people in the US die every year from accidental electrocution. Just remember that electricity is dangerous–deadly even. When it comes to getting it fixed, it’s tempting to troubleshoot the problem yourself. Parts wear out with use, and wires get loose. The fix could be simple, like a tripped circuit or a blown bulb, or there could be bigger problems at play. So when a switch doesn’t turn on, it’s a big inconvenience. Use a twist-on wire connector to make a splice.Īs marked before from the original switch, one wire (either power in, or the wire to the light fixture) goes to the black terminal, two wires go to the brass screws, and the bare copper wire (not visible here) goes to the ground screw.Many homes, especially older ones, have limited lighting, to begin with. If the wires from the old switch are too short to install the new switch (or outlet), add a length of wire. Threeway and four-way switches don’t have a top, so they can be installed in any orientation. Make sure to install the switch in the correct orientation. Simple light switch wiring have a mark to indicate which end of the switch is the top, or “up,” so that when the handle is down, the switch is off. The two black wires go to the brass terminals, and the bare copper wire is connected to the ground screw.
0 Comments
Leave a Reply. |